Back to home page

DOS ain't dead

Forum index page

Log in | Register

Back to the forum
Board view  Mix view

ActionTec PCMCIA FastNet Plus PE1500 DOS driver needed (Users)

posted by RayeR(R) Homepage, CZ, 29.09.2015, 23:43

> This one?
> http://www.wou.edu/~bwitt/SMC%20PCMCIA%20Ethernet%20Card/
> http://bama.ua.edu/~recovery/Files/Drivers/SMC%20PCMCIA%20Driver/
> http://ifsc2.ifsc.usp.br/drivers/LAN/PCMCIA/TRUST/
> IF not, try search internet for "TX100NDS.SYS"
> Hope this helps. :)

Thanks, you're my hero! :)
I found, that there was not problem in packet driver itself but PCMCIA enabler (a real mess of various manufacturers under DOS). I found that if I load packet driver for ActionTec PE200 under Win98 where I pass args of IQR and port acquired from devmgr then the driver loads OK displaying right MAC. But not under DOS with same args. Then I tried enabler (lanen.exe, 11483B) from your link and voala, packet driver loaded successfully. landiag also passed. So I uplpoaded doslinks on this old Toshiba Sattelite 470CDT and kicked up the network connection and just sending this post. Hope it doesn't crash :)

---
DOS gives me freedom to unlimited HW access.

 

Complete thread:

Back to the forum
Board view  Mix view
15111 Postings in 1359 Threads, 247 registered users, 16 users online (0 registered, 16 guests)
DOS ain't dead | Admin contact
RSS Feed
powered by my little forum