Back to home page

DOS ain't dead

Forum index page

Log in | Register

Back to the forum
Board view  Mix view

uart interrupt tx rx in Dos32 bit open watcom (Developers)

posted by Brian_extended, 16.11.2013, 01:14
(edited by Brian_extended on 16.11.2013, 01:25)

> Hi,
> I'm trying to develop an application, that use interrupt for serial port,
> to manage the receive and transmit event in Freedos 1.0 and dos4gw.

>
> Anybody has an example of a serial transmission, using the tx interrupt of
> the uart?
>
> Thanks in advance,
>
> maui

I'm in the middle of converting my TX/RX serial code to Phar Lap/Microway 32-bit code. I'm debugging it still, so will post my 16-bit code that was written "in the day". I seem to recall some Bit needing to be set that was not in the Technical Reference manual and I had to disassemble ST240 to figure out how they did it. I have hand-written corrections to that section of the IBM Tech Ref Manual.

I have a version for C++ 1.52, real mode. New version is at a Clean assemble in 386asm, need to debug it.



Turns out to be too long to load into a thread...

 

Complete thread:

Back to the forum
Board view  Mix view
22762 Postings in 2122 Threads, 402 registered users (0 online)
DOS ain't dead | Admin contact
RSS Feed
powered by my little forum