Using Fabrice Bellard's runcom to run COM files under Linux (Announce)
> > > Hence, investing in this kind of technology at this point doesn't
> really
> > > make sense, since for direct usage there are mature solutions like
> > dosemu.
>
> Look up libx86 sometime...
> Linux folks aren;t as unconcerned about realmode instructions as you might
> think.
For what? Doing a few "detection" calls during startup on a minimal emulator?
Because that is what it is mainly for, I used it when I still had a bunch of desktop powermacs. One would switch OF (the Apple firmware/bootloader) and kernel to serial, and then use a normal x86 videocard (and not some overpriced mac specific ATI card with an already old chipset), and then libx86 would initialize the videocard.
I'm not sure if it is still used much, since most bioses support the most basic functionality (init SATA, and I assume the video bios too) via 32-bit calls?
The fact that that page mentions alpha (which is essentially dead since before 2000) says enough.....
Complete thread:
- Using Fabrice Bellard's runcom to run COM files under Linux - Arjay, 21.03.2012, 01:17 (Announce)
- Using Fabrice Bellard's runcom to run COM files under Linux - marcov, 21.03.2012, 13:43
- Using Fabrice Bellard's runcom to run COM files under Linux - Arjay, 21.03.2012, 19:53
- Using Fabrice Bellard's runcom to run COM files under Linux - Ibidem, 30.03.2012, 01:00
- Using Fabrice Bellard's runcom to run COM files under Linux - Rugxulo, 31.03.2012, 00:47
- Using Fabrice Bellard's runcom to run COM files under Linux - marcov, 31.03.2012, 09:15
- libx86 / Alpha - Rugxulo, 10.04.2012, 00:26
- Using Fabrice Bellard's runcom to run COM files under Linux - Ibidem, 30.03.2012, 01:00
- Using Fabrice Bellard's runcom to run COM files under Linux - Rugxulo, 19.04.2012, 05:40
- Using Fabrice Bellard's runcom to run COM files under Linux - Arjay, 21.03.2012, 19:53
- Emu8080-Stefan Tramm's Intel 8080 CPU Emulator running CP/M - Arjay, 16.04.2012, 21:14
- Emu8080-Stefan Tramm's Intel 8080 CPU Emulator running CP/M - Rugxulo, 17.04.2012, 00:03
- Emu8080-Stefan Tramm's Intel 8080 CPU Emulator running CP/M - Ibidem, 17.04.2012, 08:47
- Emu8080-Stefan Tramm's Intel 8080 CPU Emulator running CP/M - Rugxulo, 17.04.2012, 19:49
- Grant Searle's CP/M on breadboard - updated 21st April 2012 - Arjay, 22.04.2012, 18:57
- Grant Searle's CP/M on breadboard - updated 26th April 2012 - Arjay, 04.05.2012, 22:54
- Grant Searle's CP/M on breadboard - updated 26th April 2012 - Arjay, 02.08.2012, 00:37
- Grant Searle's CP/M on breadboard - updated 23th July 2013 - Arjay, 05.08.2013, 19:05
- Grant Searle's CP/M on breadboard - updated 26th April 2012 - Arjay, 02.08.2012, 00:37
- Grant Searle's CP/M on breadboard - updated 26th April 2012 - Arjay, 04.05.2012, 22:54
- Using Fabrice Bellard's runcom to run COM files under Linux - marcov, 21.03.2012, 13:43