DOS ain't dead

JEMM386 noems (Users)

posted by georgpotthast , Germany, 12.02.2013, 21:47

Now I tried JEMM386.exe instead of emm386.exe with MS DOS.

So in config.sys I have the line: "device=c:\jemm386.exe noems".

When I start tlink the PC does not boot any more instead I get the message:

"Unhandled exception 000E at 0020 1CAD Errcode 0002"

What does that mean?

I also found the following: if I start tlink a second and a third time from the command line without adding a file name to link, at the third time everything works fine. The same happens when I load TD, the debugger, from the command line. This starts fine on the third time and thereafter.

So is there a way to get tlink to run on the first time

Georg

Complete thread:

• NOEMS - georgpotthast, 02.02.2013, 07:53 (Users)
  • NOEMS - Arjay, 02.02.2013, 11:13
  • NOEMS - Japheth, 02.02.2013, 12:25
    • NOEMS - Arjay, 02.02.2013, 13:00
      • NOEMS - Rugxulo, 02.02.2013, 17:03
      • NOEMS - Arjay, 09.02.2013, 22:23
  • NOEMS - tom, 02.02.2013, 17:27
  • NOEMS - georgpotthast, 03.02.2013, 19:48
    • NOEMS - Rugxulo, 03.02.2013, 23:00
      • NOEMS - Japheth, 04.02.2013, 09:04
    • NOEMS - tlink - Arjay, 10.02.2013, 14:05
      • NOEMS - tlink - georgpotthast, 12.02.2013, 21:50
  • JEMM386 noems - georgpotthast, 12.02.2013, 21:47
    • JEMM386 noems - RayeR, 13.02.2013, 00:23
    • JEMM386 noems - Japheth, 13.02.2013, 04:15
    • JEMM386 noems - Laaca, 13.02.2013, 07:20