DOS ain't dead - controlling GPIOs from DOS

controlling GPIOs from DOS (Announce)

posted by Damien, 03.12.2013, 22:54

Hello,

I am looking for a nice way to exchange information between a dos program and "the real world".
Of course there are Parallel and Serial ports (on mother board on PCI board).
But I would like something more efficient, for example writing/reading directly a 32 bit value via PCI port.

I have been looking for a chip that performs the PCI interface and proposes GPIO, but I haven't really found... Idealy a cheap and simple PCI card could propose this ?
Does someone knows anything like this?

Thanks.

Post reply

Complete thread:

controlling GPIOs from DOS - Damien, 03.12.2013, 22:54 (Announce)
- controlling GPIOs from DOS - RayeR, 04.12.2013, 01:08
  - controlling GPIOs from DOS - Damien, 04.12.2013, 21:27
    - controlling GPIOs from DOS - RayeR, 05.12.2013, 01:07
- controlling GPIOs from DOS - bretjohn, 04.12.2013, 17:26
  - controlling GPIOs from DOS - Damien, 04.12.2013, 21:38
    - controlling GPIOs from DOS - bretjohn, 05.12.2013, 03:18
      - controlling GPIOs from DOS - RayeR, 05.12.2013, 10:59
        controlling GPIOs from DOS - bretjohn, 05.12.2013, 16:28
        controlling GPIOs from DOS - RayeR, 06.12.2013, 03:09
        controlling GPIOs from DOS - Zyzzle, 06.12.2013, 07:57
        controlling GPIOs from DOS - Damien, 05.12.2013, 19:45
      - controlling GPIOs from DOS - Damien, 05.12.2013, 19:55
        controlling GPIOs from DOS - RayeR, 06.12.2013, 03:17
        controlling GPIOs from DOS - Damien, 07.12.2013, 00:39
        controlling GPIOs from DOS - RayeR, 08.12.2013, 03:01
        controlling GPIOs from DOS - bretjohn, 09.12.2013, 05:15